Filter
Top Products
8
EN
Radio
Selecting Tuner Band
1. Press SOURCE to select TUNER.
2. Press BAND to select between AM or FM radio
band.
Tip: Your audio system has 32 preset stations.
Tuning to a Station
Press SKIP FORWARD / SKIP BACKWARD
to select frequencies.
Using Presets
The tuner can be in either TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
• Press TUNE/PRESET to toggle TUNE and PRESET
mode.
• Press SKIP FORWARD or SKIP
BACKWARD on the main system or
PRESET UP or DOWN on the remote control to
access the previous or next preset station. The
display first shows the preset program number
and after a few seconds, the frequency will be
displayed. (FMPR:01 is FM preset 1)
Auto Preset Programming
(FM only)
Press and hold BAND button for 2 seconds to scan
stations in FM band. The stations will then be stored
as preset channels. A maximum of 32 stations can be
stored. Beware of your preset channels being erased
accidentally because the scanning and storing process
is automatic upon pressing the button. You can stop
the automatic scan by pressing any button, but the
erased stations cannot be recovered.
Manually Setting Presets
1. Press TUNE/PRESET button to enter TUNE mode.
2. Press SKIP FORWARD / SKIP
BACKWARD to access the desired
frequency.
3. Press the PROG./SET button once.
4. The most recently accessed program location will
be displayed.
5. If a different program location is preferred, press
SKIP FORWARD / SKIP BACKWARD
to move to the desired preset number (1-32).
6. Press PROG./SET to store the selected frequency
at that preset.
Suppressing Stereo Signal
Press FM ST to toggle between FM mono and stereo
for stereo FM stations. (Remote Only)
AUTO
87.50 MHz
OPEN/CLOSE
POWER
STANDBY
DIMMER/
DEMO
SOURCE DISC SKIP
PHONES
REPEAT
DIRECT DISC ACCESS
12345
BAND
AUTO PROG.
TUNE/PRESET
TIMER
CD DISPLAY
CLOCK PROG./SET
UP
DOWN
Bass
Boost
ROCK/CLASSIC
CUSTOM
/FLAT
POP/JAZZ
PR:01
RS2600-EN rev.1 3/1/02 4:20 PM Page 12