Filter
Top Products
Selecting Tuner Band
1. Press SOURCE to select TUNER.
2. Press BAND to select radio band.
Tuning to a Station
Press SKIP BACKWARD or SKIP FORWARD
to select frequencies.
Using Presets
The tuner can be in either TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
• Press TUNE•PRESET to toggle TUNE and
PRESET mode.
• Press SKIP BACKWARD or SKIP
FORWARD on the main system or PRESET
UP or DOWN on the remote control to access
the previous or next preset station. The display
first shows the preset program number and
after a few seconds, the frequency will be
displayed. (FMPR:01 is FM preset 1)
Auto Preset Programming
(FM only)
Press and hold the BAND button for 2 seconds to
scan stations in FM band. The stations will then
be stored as preset channels. A maximum of 32
stations can be stored. Beware of your preset
channels being erased accidentally because the
scanning and storing process is automatic upon
pressing the button. You can stop the automatic
scan by pressing any button, but the erased sta-
tions cannot be recovered.
Manually Setting Presets
1. Press the TUNE•PRESET button to enter TUNE
mode.
2. Press SKIP BACKWARD or SKIP
FORWARD to access the desired
frequency.
3. Press the PROG•SET button once.
4. The most recently accessed program location
will be displayed.
5. If a different program location is preferred,
press SKIP BACKWARD or SKIP
FORWARD to move to the desired preset
number (1-32).
6. Press PROG•SET to store the selected
frequency at that preset.
Suppressing Stereo Signal
Press FM ST. to toggle between FM mono and
stereo for stereo FM stations. (Remote Only)
9
EN
Radio
Tips:
Your audio system has 32 preset stations.
87.50 MH
z
PR:01
MS2200 EN 11/17/03 1:59 PM Page 14