Filter
Top Products
Getting Started
Inserting Batteries into Remote Control
Install batteries as follows:
1. Remove the battery compartment door by applying
thumb pressure on battery door and then lift the
door out and off the cabinet.
2. Insert 2 “AAA” (R03) batteries into the battery
compartment according to the + and - signs in the
compartment and replace the compartment door.
3. To use the remote control, point it directly at your
receiver.
Set up and Maintenance of the Receiver
Provide spaces for sufficient ventilation as indicated:
• Do not connect to the AC power cords until all
connections are completed.
• Do not use your set immediately after transferring it
from a cold place to a warm place: there is risk of
condensation.
• Do not expose your set to water and excessively high
temperatures.
• After having disconnected your set, clean the case
with a soft cloth, or with a slightly damp leather
chamois. Never use strong solvents.
Protect your Components from
Overheating
• Do not block ventilation holes in any component.
Arrange the components so that air can circulate
freely.
• Do not stack components directly on top of each
other.
• Do not place the unit near other components that
generate heat such as heating vents.
• Allow adequate ventilation when placing your
components in a stand.
• Place an amplifier near the top shelf of the stand so
heated air rising from it will not affect other
components. If you have a satellite receiver, you
should place it on the top shelf.
Using Headphones
To listen privately through your audio
system, use the PHONES jack on the
receiver. However, make sure you
turn down the volume before you
put on the headphones. Increase the
volume to the desired level after
headphones are in place.
Once headphones are connected, “HEADPHONE DOWN
MIX 2 CHANNEL” will scroll on display. This feature
automatically converts multi-channel speaker outputs to
2 channel stereo for your listening pleasure.
Hearing Comfort & Well-Being
• Do not play your headset at a high volume. Hearing
experts advise against continuous extended play.
• If you experience a ringing in your ears, reduce
volume or discontinue use.
EN
3
Getting Started
Unpacking the Receiver
You should receive the following items:
2
ON/ECO
SUBWOOFER SOURCE
SURROUND
PRESET
VOLUME
PHONES
+ -
+ -
One receiver unit
One pair of “AAA”
batteries
One pig-tail
antenna wire
One external AM loop
antenna
PR
SUBWOOFER
SURROUND
TUNER
DVD 6CH
ST MONO
RDS
PTY
EQUALIZER
LEVEL
NIGHT
GUIDE
SET UP
TUNER -
TUNER +
SAVE
TAPE CD
AUX 1
(VCR)
AUX 2
(SAT CABLE)
• one instruction book;
• Thomson Warranty Card;
• one Quick Connection Guide
One Remote Control
Thomson
Warranty
Card
10 cm/4"
5 cm/
2"
10 cm/4"
10 cm/
4"
10 cm/
4"
Front View
Side View
one audio cable (two
wires) with red and
white RCA connectors;
Unpacking The Speakers
• one set of speakers include 1 set of left and right
front speakers, 1 center speaker, 1 subwoofer and 1 set
of left and right rear speakers.
• 6 speaker wires including:
1 X silver wire with
white/black band for
front left speaker
1 X silver wire with
purple/black band for
subwoofer
1 X silver wire with
green/black band for
center speaker
1 X silver wire with
red/black band for front
right speaker
1 X silver wire with
blue/black band for rear
left speaker
1 X silver wire with
grey/black band for rear
right speaker
one Video cable