Filter
Top Products
22
EN
21
EN
Recording Tuner / AUX to USB
Device
1. In Tuner or AUX mode, press RECORD to start
recording.
The RECORD icon lights on the display.
Example:
1. In radio mode, select the station to record
(refer to page 19 for details).
2. Press RECORD to start recording.
3. Press STOP to stop recording.
In Tuner mode Recording
Deleting Files from USB Device or
Memory Card
1. In navigation mode, select the file to delete
using the navigation buttons (Refer to
“Navigation Controls” for details.)
2. Press DELETE on the main unit or DEL on the
remote control.
3. Rotate the Volume button on the main unit or
press UP or DOWN on the remote
control to select Yes to delete or No to cancel.
4. Press SELECT on the main unit or RIGHT /
ENTER on the remote control to confirm
selection.
If Yes is selected, the display shows memory
usage information after deleting selected file
for a few seconds, then returns to navigation
menu.
Deleting All Files
In navigation mode, press and hold DELETE on
the main unit or DEL on the remote control to
delete all the files on the USB device.
Delete?
No
> Yes
Mem Usage
141M Used
115M Free
Troubleshooting Tips
90.50MHz
FM001.MP3
00:10
Rem: 2:56:20
Note:
The encoding bitrate for tuner, CD
and AUX signal are as below:
CD / Aux : 128 kbps
Tuner : 96 kbps
Recording
Song 1
Song 2
Song 3
Song 1
Song 3
Solution
• Check power cord for a secure
connection.
• Unplug the unit for a moment,
and then plug into power
source again.
• Check the outlet by plugging in
another device.
• Increase the volume setting.
• Check connection to speakers.
• Check that you have selected
the appropriate function: CD,
Tuner.
• Make sure mute is off.
• Make sure headphones are not
plugged in.
• Check antenna connection.
• Move antenna.
• Turn off nearby electrical
appliances, such as hair dryer,
vacuum cleaner, microwave,
fluorescent lights.
• Check that CD is in the tray.
• Check that CD label is facing up.
• Check that PAUSE mode is not
on.
• Check that CD function is
selected.
• Use CD lens cleaner.
• Clean the disc.
• Try another CD.
Problem
System will
not turn
on
No sound
Poor radio
reception
CD does
not play
Problem
CD sound
skips
CD button
will not
respond, or
does not
change
discs when
you press
DISC SKIP
Remote
control
does not
work
Solution
• Clean the disc.
• Check disc for warping,
scratches, or other damage.
• Check if something is causing
the system to vibrate. If so,
move the system.
• Make sure the speakers are at
least 3 feet away or on a
different surface from the
main unit.
• Switch to another function
(Tuner) and then back
to CD.
• Check that the batteries are
properly installed.
• Replace weak batteries.
• Check the system is plugged
into power source.
• Point the remote directly at
the system’s front panel.
• Move closer to the system.
• Remove any obstacles
between the remote and the
system.
Main Unit
CS600 EN 5/3/05 4:17 PM Page 28