Filter
Top Products
7
2
22
2 Instant Install
If you are like us, the first thing you will want to do is to play
your favourite piece of music through your new SX25i. The
following instructions are written to enable you to achieve this as
quickly as possible. These are not comprehensive instructions,
but are designed to enable you to play music now!
Note:
Please take the time to read the SX25i manual thoroughly
as it incorporates many features, which will enhance its
operation.
Placement
The SX25i is a convection cooled amplifier and best results will
be achieved when placed on a solid surface with adequate
ventilation. DO NOT place on a carpeted floor or cover the
amplifier!
Place the SX25i close or near the source component in order to
make as short a connection as possible.
Turn off associated components
This minimises the potential to damage any other components
when connecting your SX25i into the system.
Connect source to SX25i
Connect the audio output from the source component to the
inputs at the rear of the SX25i. Refer to Chapter 4 for Rear Panel
information.
Connect loud speaker cables to SX25i
Connect your left and right channel loudspeaker leads to the
bindng posts at the rear of the amplifier. Refer to Chapter 4 for
Rear Panel information.
Note:
Make sure the nominal impedance of the loudspeakers is
not lower than 2Ω.