Filter
Top Products
6
1
11
1 Unpacking and Placement
Unpacking
Procedure
The SX25i is packaged for maximum protection. To open, sit the
box upright and cut the reinforced tape at the top of the box. The
product can now be removed.
Pull the foam protecting end-caps off either side of the unit and
remove the black material covering.
The SX25i Integrated amplifier is now unpacked and ready for
further installation.
Note:
Please retain all packaging material for future transport.
Box
Contents
1 x SX25i Integrated amplifier
1 x Product manual
3 x Performance analysis charts
1 x Detachable AC power cord
Placing Your
SX25i
The SX25i should generally be placed close to your source
equipment, thus keeping interconnect cabling between the SX25i
and associated components as short as practical. This will reduce
the systems susceptibility to radio frequency interference and the
negative effects associated with long cables.
Ventilation
Requirements
The SX25i is a convection cooled amplifier. For optimal
performance, the unit MUST
receive adequate ventilation.
Please do not cover the product with a cloth or similar.
Please do not mount the SX25i directly onto carpeted
surfaces.
In the event that the SX25i is to be incorporated into custom
cabinetry, please refer to the dimensional information provided in
the Physical Dimensions section of the manual (Chapter 12).
Note:
Please take all necessary steps to ensure that the unit
receives adequate ventilation