Filter
Top Products
15
Master Remote Trigger Input
The master trigger input is used to take the 6160 in and out of standby. The
master trigger input is designed to accept a 3.5mm diameter male plug. The
voltage rating is +5V to +12V DC level ON and 0V DC level OFF.
The plug must follow the specifications as per the following diagram:
Slave Remote Trigger Outputs
A parallel slave trigger output is provided to switch on or off any connecte
d
peripherals to the 6160. The slave trigger output is designed to accept a 3.5m
m
diameter male plug. The voltage rating is +12V DC level ON and 0V DC level
OFF.
The plug must follow the specifications as per the diagram below:
AC Mains Fuse
The 6160 is equipped with a user serviceable AC mains fuse. In the event o
f
fuse failure, always replace with the same type and value fuse. Remember, fuses
do not usually blow without a reason. Any doubts about fuse failure should be
conveyed directly to your Perreaux dealer.
For more information on fuse ratings, please refer to Chapter 14
“Specifications”.
Caution!
This is the ONLY
user accessible fuse.
Never replace the fuses with any other ratings other than the one
specified on the rear panel.
Always ensure your 6160 is disconnected from the mains supply before
attempting to change the mains fuse.
Power Switch
Set this switch right (I) to turn power ON. Mute relay circuitry is employed i
n
the 6160 so output is muted momentarily after the power switch is actuated. Se
t
the switch left (O) to turn the unit off, at which time the outputs will be
disconnected.