Filter
Top Products
SR4X-MM Mirror-Mount Owner’s Manual
Installation 5
Installation
Parts for TERK SR4X-MM Mirror-Mount Antenna
Figure 2. Verify that your TERK SR4X-MM Mirror-Mount package includes the above items.
NOTE: All metal mounting hardware is stainless steel.
Recommended Tools and Supplies
• Any socket tool/wrench set (to tighten machine bolts and hex nuts)
• Any tool to help cable routing (e.g., flat dental pick, screwdriver, etc.)
• Grommets and silicone sealer (for cable routes)
Installation Precautions and Tips
• When selecting an antenna location, make sure the proposed site is the highest possible and
does not interfere with the driver’s visibility of the road during vehicle operation.
• Also, at the proposed site, verify that there is at least a 20-degree clearance from any
obstruction on all sides, including any metal hardware and exhaust stacks. Installation near
fiberglass wind fairings is acceptable with minimal signal blockage.
• Prior to installation, turn off all audio systems and other electrical devices. Disconnect the (–)
negative lead from the vehicle’s battery.
• At the installation site, locate and make a note of all fuel lines, hydraulic brake lines, and
electrical wiring. Use extreme caution when cutting or drilling in and around these areas.
Always wear protective eyewear when using tools.
continued on next page...
(1) TERK SR4X-MM
Antenna Mast with
17'of Attached
Coaxial Cables
with (2) separate plastic
cases/clips
(4) 1⁄4"-20 x 2"
Hex-Head Bolts
(4) 1⁄4" Flat Washers
(4) 1⁄4"-20 Ext. Tooth
Lock Washers
(4) 1⁄4"-20 Hex Nuts
(1) 3⁄4" Flat Washer
(1) 3⁄4" Ext. Tooth Lock Washer
(1) 3⁄4"-16 Hex Thin Nut
(1) Connecting Bracket
(1) Right-Angle
Bracket
(4) Cable Tie Wraps
8.75"
36"
SR4X-MM OM 5/14/02 11:38 AM Page 5