Filter
Top Products
5
Installation and Wiring
Before making any connections always
turn off your amplifier
. Installing and wiring
your speakers is an easy and straightforward process. Enjoy your new Teresonic sound!
our speakers are equipped with highest quality WBT binding posts that are a true five-way design and
will accept 6mm (1/4") or 8mm (5/16") spades, 4mm bananas, bare wire etc. There is no need for the
complicated and extra costs of bi-wiring, there are no crossovers to adjust…just connect the speaker
cables and enjoy the music.
For optimal results Teresonic “zero interference” Clarison speaker cables are recommended to connect the
loudspeakers with your amplifier. Namely, the same ultra-high quality Clarison cables that are used inside the
speaker cabinet to connect speaker terminals in the back to the speaker driver. Using the same cables will
ensure the same character of the sound and the best overall sonic quality without coloration or distortions
Wiring
Connect the speaker wires to the terminals in the back of the speakers. For the perfect sound experience, the
right speaker must be connected to the output terminal marked "R" or "Right" on your amplifier and the left
speaker to the terminal marked "L" or "Left". A detail that is often overlooked is connection in correct phase,
i.e. the red terminal (+) on the amplifier should be connected to the red terminal (+) on the speaker, and the
white terminal (-) on the amplifier should be connected to the white terminal (-) on the speaker. (see Fig.1). If
just one speaker in a stereo or surround sound system is not connected in phase, the bass will be weak and the
overall sound will be diffuse.
Fig. 1
Chapter
Y