Filter
Top Products
INSTALLATION
1. Wire the un-terminated signal wires to the control unit according to the signal chart. A 5
Amp fast blow fuse is recommend in the 12VDC power supply line to protect the
equipment.
A
udio In
12 FT
Revision B Page 4 of 8 3/29/06
2. Plug the 3.5mm stereo plug into the audio input jack of the recording device.
3. If it is to be used, plug in the in-car microphone into the In-Car Mic jack in the side of the
receiver base.
4. Turn on the transmitter and place it in the charging cradle with the beltclip facing out.
The Charge LED will light and the In-Use LED will flash three times. If these lights do not
come on, check the connections and repeat.
Installation is complete. Refer to Operation Section for more information.
Description Color
Power +12V DC Red
Microphone Trigger
(Ground = Transmitter On)
Black
Left Channel (Ground to
enable Inside Microphone)
Yellow
Power Ground Orange
AUX (Panic) Trigger
12V+ DC Output when EMG
button is pushed
White
Un-terminated wires
Description Position
Inside Car Mic Audio
Tip
Transmitter Audio
Ring
Audio Ground
Sleeve
Sleeve
Ring
Tip