Teac W-860R Stereo System User Manual


 
ENGLISH
15
Troubleshooting Specifications
Basic troubleshooting of a cassette tape deck is similar to
troubleshooting of any other electrical or electronic equipment.
Always check the most obvious possible causes first. To give
you a few ideas of what to look for, check the following:
No power
® Is the power cord connected?
The deck starts to play suddenly
® Set the TIMER switch to OFF.
No audio output
® Check the connections to the stereo system.
Low sound quality
® If the heads are dirty or magnetized, clean/demagnetize the
heads.
® Has the correct NR System been selected?
Strange Sound
® Set the PITCH CONTROL knob to the center
(
normal
speed).
Impossible to enter the record mode
® If the record protection tabs of the cassette tape are
broken off, cover the hole with adhesive tape.
® Turn the REC LEVEL knob to the right.
Remote control unit operation is impossible.
® Press the power switch of the main unit.
® Insert or change the batteries of the remote control unit.
Track System:
4-track, 2-channel stereo
Heads:
Deck l; 1 Erase and 1 Record/ Playback (rotating)
Deck II; 1 Erase and 1 Record/ Playback (rotating)
Type of Tape:
Cassette tape C-60 and C-90
(
Philips type
)
Tape Speeds:
4.76 cm/sec
(
1-7/8 ips)
9.5 cm/sec
(
3-3/4 ips; in Hi-Speed Dub)
Pitch Control:
±
10%
Motors:
2 DC Servo motors
(
1 ea. Deck)
Wow and Flutter
(
WRMS
)
:
0.09%.
Frequency Response
(
Overall, -20 dB
)
:
25-19,000 Hz, Metal tape
25-18,000 Hz, CrO
2 tape
25-17,000 Hz, Normal tape
Signal-to-Noise Ratio
(
Overall):
59 dB
(
NR off, 3% THD Level, Weighted)
69 dB
(
Dolby B NR on, over 5 kHz
)
79 dB (Dolby C NR on, over 1 kHz)
Fast Winding Time:
Approximately 110 seconds for C-60
Inputs:
Line: 97 mV, 50k ohms
Mic: 0.38 mV, 200 ohms
Outputs:
Line: 0.52 V for load impedance of 50k ohms or more
Headphones: 1 mW/8 ohms
Power Requirements:
120/230 V AC, 50/60 Hz (General Export Model)
120 V AC, 60 Hz (U.S.A./Canada Model)
230 V AC, 50 Hz (Europe/UK Model)
240 V AC, 50 Hz (Australia Model)
Power Consumption:
22 W
Dimensions
(
W x H x D
)
:
435 x 127 x 292 mm
(
17-1/8" x 4-15/16" x 11-1/2"
)
Weight (net):
4.0 kg
(
8-13/16 Ibs.
)
Standard Accessories:
Wireless Remote Control Unit (RC-615)
Battery (SUM-3,"AA","R6"type) x 2
Input-output connection cords
Improvements may result in specification or feature changing
without notice.
Dolby noise reduction and HX Pro headroom extension
manufactured under license from Dolby Laboratories
Licensing Corporation. HX Pro originated by Bang & Olufsen.
"DOLBY", the double-D symbol
and "HX PRO" are
trademarks of Dolby Laboratories Licensing Corporation.