Teac W-890R Cassette Player User Manual


 
5
ENGLISH
Introduction
Before connecting and using the unit, please take time to read this
manual thoroughly to ensure you understand how to properly set
up and connect the W-890R, as well as the operation of its many
useful and convenient functions. After you have finished reading this
manual, please keep it in a safe place for future reference
Dolby NR
Dolby NR is designed to reduce tape hiss, a noise introduced during
the recording and playback processes. This cassette deck is equipped
with Dolby B-type Noise Reduction.
The Dolby NR system affects both recording and playback quality. In
playback, be sure to set the DOLBY NR switch to the same position
used when the recording was made.
Supplied accessories
In addition to this manual, the W-890R has been packed with the
following:
< Remote control unit (RC-1277) x 1
< Batteries (AA) for remote control unit x 2
< Stereo RCA pin cable x 2
< Owner’s manual (this document) x 1
< Warranty card x 1
Contact your TEAC supplier if any of these items are missing.
About this manual
In this manual, we use the following conventions:
< The names of keys and controls are given in the following typeface:
EJECT.
< The alphanumeric portion of the display shows a message, this is
shown in the following typeface:
%2.
< If a preset indicator in the display (i.e. one which cannot change,
but is either on or off) is shown, this is shown as follows:
PARALLEL.
Precautions and notes for placement and use
The W-890R may be used in most areas, but to maintain top
performance, and prolong operating life, observe the following notes,
precautions and environmental conditions:
< Avoid exposing it to extremes of temperature and humidity and
avoid mechanical shocks and vibration.
< Keep the unit away from strong magnetic fields (TV sets, computer
monitors, large electric motors, etc.).
< The nominal temperature should be between 5°C and 35°C (41°F
and 95°F).
< Relative humidity should be 30 to 90 percent.
< As the unit may become hot during operation, always leave
sufficient space above the unit for ventilation. Do not install this
unit in a confined space such as a bookcase, and do not put
anything on top of the unit.
< Avoid installing this unit on top of any heat-generating electrical
device such as a power amplifier.
< Make sure that the unit is mounted in a level position for correct
operation.
< Do not open the sealed cabinet as this might result in damage
to the circuitry or electrical shocks. If a foreign object should get
inside the unit, contact your supplier or service agency.
< When removing the power plug from the wall outlet, always pull
directory on the plug, never yank the cord.
< The voltage selector on the rear panel is only available on units
for the North American market. Please set this to match your local
supply. If you are in any doubt in this matter, consult an electrician
NOTE
When transporting the unit, always use the original packing
materials. For this reason, we strongly recommend that you save all
the packing materials that came with the W-890R, in case you need
to transport it in the future. In addition, when transporting the unit,
you should tape the cassette decks closed, using an adhesive tape
that will not spoil the finish of the unit.
About cassette tapes
CAUTION
< Do not open the cassette or pull the tape out of the cassette.
< Do not touch the tape surface.
< Do not use or store the tape in a humid or dusty place.
< Keep the tape away from any magnetic sources, such as speakers
or TVs, otherwise noise may be produced during playback or
important recordings may be erased.
Cassette tapes that you should not use
Poor performance, errors, or malfunctions may result if you use any of
the tapes described below. Some of these tapes may also cause tape
clog problems that can damage the tape transport mechanism.
Cassettes that are imperfectly shaped
Do not use a deformed cassette or one that has unstable tape
movement or makes a strange sound during fast-forward or rewind.
Long play tapes
Tapes that are longer than 90 minutes are very thin and stretch easily,
so using them can result in wow and flutter. In addition, long tapes
can become tangled in the equipment, so please use caution with
them.
Endless tapes
Do not use these tapes because they can easily get tangled in the
tape transport mechanism.