Filter
Top Products
19
ENGLISH
NOTE
High-speed dubbing makes a copy at approximately two times
the normal speed. We recommend normal speed dubbing for
best audio quality.
During dubbing, either the
NORM DUB or HIGH DUB indicator lights
steadily on the display.
During normal speed dubbing, only the following keys work:
TAEP I deck : STOP (H)
TAPE II deck : PAUSE, REC MUTE, STOP (H)
During high-speed dubbing, only the STOP (H) key works.
Neither DUB START key works immediately after the tape is fast-
forwarded or rewound to the end. Wait for 5 seconds or more
before pressing the key.
NOTE
< During dubbing, the pitch control does not work.
< Recording level adjustment is not necessary for dubbing, as
the recording level is set to the level of the pre-recorded tape.
Operating the REC LEVEL control, before or after starting
dubbing, has no effect at all.
< If a nearby television set is switched on during high-speed
dubbing, a high-pitched interference noise may be recorded on
the tape. To avoid this, either perform dubbing at normal speed,
or turn off the television.
< If you want to start dubbing using the remote control unit, press
the two DUB START keys (NORMAL keys or HIGH keys), for
either normal or high speed dubbing, on the remote control unit
at the same time.
Editing during dubbing (only at normal speed)
You can prevent unwanted songs or unnecessarily long blanks from
being dubbed, or you can create blanks between songs.
1. At the desired point during dubbing, press the PAUSE key
on the TAPE I deck. The TAPE II deck only enters the pause
mode, allowing you to let unwanted songs go by.
To create a 4-second blank between songs, press the REC MUTE
key on the TAPE II deck. The TAPE II deck temporarily stops after
recording no signal for 4 seconds.
The TAPE I deck continues playback when the TAPE II deck is in
pause mode.
2. To resume dubbing, press the PAUSE key on the TAPE II
deck.