Filter
Top Products
26
Listening to an External Source
See pages 6 - 7 “Connections”.
1
Connect a portable audio player to the AUDIO
jacks using the supplied RCA pin-stereo mini
plug cable
(page
s 6 - 7
D
).
2
Press the FUNCTION button repeatedly to
select “AUX”.
3
Play the source, and adjust the volume using
the VOLUME buttons and the connected
portable audio player.
< When using the headphones jack of the component,
if you do not adjust its volume, you might not hear
any sound from SR-80i.
< Turning the volume of the connected component
up too high might cause the sound from SR-80i to
be distorted. In this case, reduce the volume of the
component until the distortion stops and then adjust
the volume level of SR-80i to a comfortable listening
level.
The unit can be programmed to turn on and standby at a
specified time.
You can set the unit to play an iPod/iPhone, FM/AM radio
or a USB flash memory.
You can also set two separate timers with ALARM 1 and
ALARM 2.
Setting the wake up timer
The procedures below are to set ALARM 1.
Follow similar steps to set ALARM 2.
o This operation is available in every sound source.
1
Press and hold the ALARM 1 button for more
than 2 seconds.
Hold down
more than 2 sec.
Example:
“ON TIME” appears on the display.
The clock hour value and the wake up timer indicator
(
) blink.
o If no button is pressed for more than 10 seconds, the
wake up timer setting mode will be cancelled.
2
Press the Skip (
.
/
/
) buttons to set the on
time (hour), and then press the ALARM 1
button.
The minutes value blinks.
Wake Up Timer