Filter
Top Products
ENGLISH
98
You can mount the R-X1 on a wall.
Precautions
<
Be aware of the best possible direction
for receiving AM broadcasts (this unit has
no AM anntena you can turn around).
<
Leave sufficient space above the unit to
extend the FM telescopic antenna.
< Pay attention to the length of the AC
adaptor.
< Drill holes into solid wall support, such as
wooden frame or concrete wall.
< TEAC supplies these brackets as a
convenience to the product owner.
Consult your local building codes and
exercise all necessary caution when
mounting these brackets. If you are
unsure how to use the supplied brackets,
consult with a local tradesmen or
building supply expert.
To hook on the wall
1. Fix the brackets on the rear panel of
the R-X1 using the supplied short
screws.
2. If the AC adapter has not been
connected, connect it to the DC IN
jack of the R-X1.
The provided Remote Control Unit allows
the unit to be operated from a distance.
When operating the remote control unit,
point it towards the remote sensor on the
front panel of the unit.
<
Even if the remote control unit is
operated within the effective range,
remote control operation may be
impossible if there are any obstacles
between the unit and the remote control.
<
If the remote control unit is operated near
other products which generate infrared
rays, or if other remote control devices
using infrared rays are used near the unit,
it may operate incorrectly. Conversely, the
other products may also operate
incorrectly.
1
2
3
1. Remove the battery compartment cover.
2. Put in the lithium battery (CR2032, 3V).
3. Close the cover.
Battery Replacement
If the distance required between the
remote control unit and main unit
decreases, the battery is exhausted. In this
case, replace the battery with a new one.
Precautions concerning batteries
Do not heat or disassemble batteries and
never dispose of old batteries by throwing
them in a fire.
Remote Control Unit
Battery Installation
Wall Mounting
3. Use the supplied guide sheet to mark
the exact drilling points on the wall.
4. Drill holes in the wall at the marked
points.
5. Screw the supplied long screws into
the wall.
Leave about 5 mm space between the
screw’s head and the wall.
< As a convenience, a set of tapered plastic
anchors is supplied. If you chose to use
these anchors, drill a pilot hole using a 6
mm drill bit then tap the anchor into the
pilot hole.
Only use these anchors if they are
appropriate for the materials onto which
the unit is to be mounted. Consult your
local hardware store if you are uncertain.
6. Carefully hang the R-X1 onto the
screws.
Note:
<
Ensure that the unit locks onto the hooks
and that the hooks are strong enough to
support the weight before removing your
hands.