Filter
Top Products
40
If you have problems with your system, look through this
chart and see if you can solve the problem yourself before
calling your dealer or TEAC service center.
General
No power.
e Check the connection to the AC power supply. Check
and make sure the AC source is not a switched outlet
and that, if it is, the switch is turned on. Make sure
there is power to the AC outlet by plugging another
item such as a lamp or fan into the outlet.
No sound from speakers.
e Select the source using the SOURCE button.
e Check the connection to the speakers.
e Adjust the volume.
e Pull out the headphone plug from the PHONES jack.
e If “MUTING” is displayed, press the MUTING button.
The sound is noisy.
e The unit is too close to a TV or similar appliances.
Install the unit away from them, or turn them off.
Remote control does not work.
e Press the STANDBY/ON button to turn the unit on.
e If the batteries are exhausted, change the batteries.
e Use remote control unit within the range (5 m/16-2/5
ft.) and point it at the front panel.
e Clear obstacles between the remote control unit and
the main unit.
e If a strong light is near the unit, turn it off.
CD Player
Will not play.
e Load a disc with the label side up.
e If the disc is dirty, clean the surface of the disc.
e A blank disc has been loaded. Load a prerecorded
disc.
e Depending on the disc, etc. it may not be possible to
play back CD-R/RW discs. Try again with another disc.
e You cannot play back unfinalized CD-R/RW discs.
Finalize such a disc in a CD recorder and try again.
Sound skips.
e Place the unit on a stable place to avoid vibration
and shock.
e If the disc is dirty, clean the surface of the disc.
e Do not use scratched, damaged or warped discs.
Troubleshooting
MP3/WMA
There is no sound even if the Play/Pause button (y/
J) is pressed.
e Check the file format. Non-playable file formats (e.g
MPEG 1 LAYER 2 file) cannot be played.
“No song title No artist No album” appears on the
display.
e There is no ID3 tag information for the music file. Edit
the title, artist, and album information of the song on
a PC using the MP3 or WMA making application.
Some unknown characters are displayed on the
display panel.
e This unit cannot display symbols and full-size or
double-byte characters (such as Japanese, Chinese,
etc.) correctly. File name of MP3 or WMA must be
alphanumeric characters only.
iPod Player
Cannot insert the iPod.
e Check the dock adapter.
e Remove dust or obstacles from the Dock connector
of the CR-H238i and the iPod, then insert the iPod
again.
Will not play.
e Remove the iPod from the dock, wait a few seconds,
and insert it again.
e Software update may solve the problem. Visit
the Apple website and download the latest iPod
Software.
FM/AM Tuner
Cannot listen to any station, or signal is too weak.
e Tune in the station properly.
e Rotate the FM or AM antenna for the best reception
position.
e An external antenna is recommended.
Though the broadcast is stereo, it sounds monaural.
e Press the FM MODE button.
If normal operation cannot be recovered, unplug the
power cord from the outlet and plug it in again.