Filter
Top Products
9
ENGLISH
Tape Monitor Function
If you want to select the source connected to TAPE 2 jacks,
press the TAPE 2 MONITOR button to turn the tape monitor
function on. The TAPE 2 MONITOR indicator lights.
Press the TAPE MONITOR button again to cancel the tape
monitor function.
<
When the tape monitor function is on, sources other than
TAPE 2 cannot be heard. Be sure to turn the function off
while listening to other sources.
Play the source, and gradually turn up the volume to
the required level by turning the VOLUME knob.
5
Recording
1. Select a source to be recorded by turning the INPUT
SELECTOR.
2. Start recording.
<
The volume and tone control have no effect on the recording
signals.
< If a 3-head cassette tape deck is connected to TAPE 2 (PLAY
and REC) jacks, and if the tape monitor function is set to on
during recording, you can listen to not the source sound but
the sound being recorded. Press the TAPE MONITOR button
to turn on or off the tape monitor function.
Selecting the speakers
For private listening, first reduce the volume level on the
receiver to minimum. Then insert the plug from your
headphones into the PHONES jack, and adjust the volume by
turning the VOLUME knob.
If you want to cut off the sound from speakers, press the
SPEAKERS button to turn it off.
CAUTION
Always lower the volume level prior to plugging in your
headphones. TO AVOID DAMAGING YOUR HEARING - Do
not place your headphones on your head until after you have
plugged them in.
Press the SPEAKERS button (A or B) to turn the speakers on or
off.
Listening through headphones