5
ENGLISH
AUDIO IN/OUT jacks
Analog 2-channel audio signal is input or output from these
jacks. Connect the component with commercially-available
RCA cables.
Make sure to connect:
white plug q
white jack (L: left channel)
red plug q
red jack (R: right channel)
PHONO jacks/SIGNAL GND terminal
Connect the turntable’s RCA pin cords to PHONO jacks.
Make sure to connect:
white plug q
white jack (L: left channel)
red plug q
red jack (R: right channel)
Connect the turntable’s ground cord to SIGNAL GND
terminal.
AC Outlet (switched)
This outlet is active only when the unit is on.
Caution:
Make sure that the total power consumption of all
equipment connected to the outlet does not exceed 500mA
or 100 watts.
REMOTE CONTROL jacks
If you have TEAC T-R610, connect the REMOTE CONTROL
jack (A or B) of each component by the remote control cord
(provided with the T-R610).
Power cord (AC)
Be sure to connect the power cord to an AC outlet which
supplies the correct voltage.
Hold the power plug when plugging or unplugging the
power cord. Never pull or yank on the power cord.
F
E
D
C
B
Speaker Connections
Caution:
To avoid damaging the speakers with a sudden high-level
signal, be sure to switch the power off before connecting
the speakers.
<
Check the impedance of your speakers. Connect speaker
with an impedance of 4 to 16 ohms when using only one
pair of speakers (SPEAKERS A or SPEAKERS B). When using
two pairs of speakers simultaneously, the impedance should
be 8 to 16 ohms.
<
The black speaker terminals are _ (negative).
Generally, the +
side of the speaker cable is marked to
make it distinguishable from the _
side of the cable.
Connect this marked side to the +
terminal and the
unmarked side to the black _
terminal.
<
Prepare the speaker cables for connection by stripping off
approximately 10 mm or less of the outer insulation.
(Removing too much insulation may lead to a short circuit if
the bared wires should come in contact with each other.)
Twist the strands of the stripped wires tightly together:
Caution:
The metal portions of the two separate wires should not
touch or an electrical short can occur. Shorted wires can
create a fire hazard or induce a failure in your equipment.
How to connect
Speakers A
1.Turn the terminal cap counterclockwise
to loosen it. The speaker terminal caps
cannot be fully removed from the base.
2.Insert the wire into the terminal fully and
turn the terminal cap clockwise to
securely connect it .
Speakers B
Press the lever, insert the wire, then
release the lever.
<
Make sure none of the wire insulation is under the terminal,
only the bare, stripped wire.
<
Make sure the wire is fastened firmly by pulling the cable
lightly.
A