Filter
Top Products
8
To protect speakers from a sudden high-level signal,
turn the VOLUME knob counterclockwise to minimize
the volume.
(infinity): minimum volume
0dB: maximum volume
Press the POWER switch.
The unit enters standby mode, and the standby indicator
lights.
Press the STANDBY/ON switch to turn the unit on.
The standby indicator goes off.
Select a source by turning the INPUT SELECTOR (or
pressing one of the input buttons of the remote control
unit).
4
3
2
1
Remote Control Unit
The amplifier and some other TEAC components which have
mark on the front panel can be operated by the provided “UR”
remote control unit.
When operating the remote control unit, point it towards the
REMOTE SENSOR on the front panel of the amplifier (or other
TEAC component).
<
Even if the remote control unit is operated within the effective
range, remote control operation may be impossible if there
are any obstacles between the unit and the remote control.
<
If the remote control unit is operated near other appliances
which generate infrared rays, or if other remote control
devices using infrared rays are used near the unit, it may
operate incorrectly. Conversely, the other appliances may
operate incorrectly.
Battery Installation
1. Remove the battery compartment cover.
2. Insert two “AAA” (R03 or UM-4) dry batteries. Make sure that
the batteries are inserted with their positive “+” and negative
“_
” poles positioned correctly.
3. Close the cover.
Battery Replacement
If the distance required between the remote control unit and
main unit decreases, the batteries are exhausted. In this case
replace the batteries with new ones.
Precautions concerning batteries
<
Be sure to insert the batteries with correct positive “+” and
negative “_
” polarities.
<
Use batteries of the same type. Never use different types of
batteries together.
<
Rechargeable and non-rechargeable batteries can be used.
Refer to the precautions on their labels.
<
When the remote control unit is not to be used for a long
time (more than a month), remove the batteries from the
remote control unit to prevent them from leaking. If they leak,
wipe away the liquid inside the battery compartment and
replace the batteries with new ones.
<
Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.
Basic Operation 1
42 1 5
3
TAPE 2
MONITOR