TC electronic SDN BHD D22 Stereo Amplifier User Manual


 
28
MASTER FADER
Why make a Master Fader?
The Master Fader makes it possible to perform a manual fade on the very Output of the D22 enabling you to keep your fade in the
Digital domain to ensure perfect tracking of left and right.
Connecting and Calibrating the Master Fader
In order to work the Master Fader accurately, the D22 must be calibrated:
- Connect the Master Fader to the “GPI” Input.
- Press and hold the BYPASS key of the D22 while powering up.
- Scroll down to “Fader Calibration” using the MENU keys, and press the OK key.
- Move the Master Fader to maximum position. To compensate for mechanical tolerances draw back the Master Fader slightly.
- Press OK.
- Move the Master Fader to minimum position. To compensate for mechanical tolerances raise the Master Fader slightly.
- Press OK.
- The Master Fader is now Calibrated. Power On/Off.
Activating the Master Fader
To activate the Master Fader, enter the Utility menu and scroll down to “GPI External Input” using the MENU keys.
Dial the ADJUST wheel to choose “FADER”.
The Master Fader is now controlling the Digital fader of the D22. The Fader located in the D22 output section will now
follow and display the movement of the Master Fader.
Cables and Lengths
The Master Fader uses standard mono jack cables. The cable can be extended using the jack to jack adapter, and can run at cable
lengths up to 100 meters. Remember to recalibrate after extending the cable.