8 TASCAM CD-160MKll
1 − Introduction
The CD-160MKII has been designed for the playback
of CD-DA (standard audio) format discs and MP3 files
recorded on the discs using the ISO9660 format: In addi
-
tion to ordinary 5-inch and 3-inch CDs.
Always place the compact discs in the trays with their
label facing upward.
To remove a disc from its case, press down on the center
of the disc holder, then lift the disc out, holding it care
-
fully by the edges.
Do not use any record spray, anti-static solutions, ben
-
zene, paint thinner or other chemical agents to clean
CDs as they could damage the delicate playing surface.
It may cause CDs to become unplayable.
Discs should be returned to their cases after use to avoid
dirt as well as serious scratches that could cause the
laser pickup to “skip.”
Avoid getting fingerprints on the signal side (the non-
label side). Grime and dust may cause skipping, so keep
discs clean and store them in their cases when not being
played. To clean the signal side of a disc, wipe gently
with a soft dry cloth from the center towards the outside
edge.
Keep discs away from direct sunlight, and places of
high heat and humidity. If left in such places, warping
could result.
Do not affix any labels or stickers to the label side of the
disc and do not use any protective coating spray.
Do not insert discs that have adhesive remaining from
•
•
•
•
•
•
•
•
tape or stickers that have been removed. If they are
inserted into the player, they could stick to the internal
mechanism, requiring removal by a technician.
Do not use cracked discs.
Only use circular compact discs. Avoid using non-circu
-
lar promotional, etc. discs.
The CD-160MKll cannot play unfinalized CD-R/RW
discs.
CD-R and CD-RW discs are sensitive to the effects of
heat and ultraviolet rays. It is important that they are not
stored in a location where direct sunlight will fall on
them, and which is away from sources of heat such as
radiators or heat-generating electrical devices.
When labeling CD-R and CD-RW discs, always use a
soft oil-based felt-tipped pen to write the information.
Never use a ball-point or hard-tipped pen, as this may
cause damage to the recorded side.
If you are in any doubt as to the care and handling of a
CD-R and CD-RW discs, read the precautions supplied
with the disc, or contact the disc manufacturer directly.
Music discs with copy control, a copy-protection sys
-
tem, have been released form several record companies
in an attempt to protect the copyright. Since some of
these discs do not comply with the CD specifications,
they may not be playable on the CD-160MKII.
•
•
•
•
•
•
•
Handling of compact discs
About discs
Conventional audio CDs bearing the COMPACT DISC
DIGITAL AUDIO logo on the label:
Properly finalized CD-R and CD-RW discs.
NOTE
Depending on the quality of the disc and/or the
condition of the recording, some CD-R/CD-RW discs
•
•
•
may not be playable.
Copy-protected discs and other discs that do not
conform to the CD standard may not play back cor-
rectly in this player. If you use such discs in this unit,
TEAC Corporation and its subsidiaries cannot be
responsible for any consequences or guarantee the
quality of reproduction. If you experience problems
with such non-standard discs, you should contact
the producers of the disc.
•