Filter
Top Products
12
Playback
Playback 1 (either TAPE 1 or TAPE 2)
1
Switch on the POWER.
2
Load a pre-recorded tape into the TAPE 1 or 2 deck.
Press the EJECT key (L) to open the cassette compartment.
Insert the cassette tape with its open edge facing down, the
desired side facing you. Then, close the cassette compartment by
pushing on its front part.
Side “A” facing you
This cassette deck can play back normal (Type I), high position
(Type II) and metal (Type IV) tapes.
For the sake of simplicity, we refer to the tape side facing you as
Side “A” and to the tape side facing away as Side “B”. When you
insert a cassette with Sides “A” and “B” reversed, Side “A” should
read Side “B” and Side “B” should read Side “A”.
3
Select a reverse mode setting using the REV MODE switch.
You have a choice of three settings:
7: One way mode
Set the switch to this position to playback only one side.
j: Two way mode
Set the switch to this position to play back both sides
of the tape in one session. When playback reaches the
end of side “A”, the playback direction is automatically
reversed, and playback continues on side “B”.
p: Repeat mode
Set the switch to this position. Both sides of the tape are
played back as many as 5 times.
If a tape is in both the TAPE 1 and TAPE 2 compartments,
the TAPE 1 and TAPE 2 decks continuously play the tapes.
4
Press the PLAY (h or y) key.
Pressing the y key starts playback from side “A”.
Pressing the h key starts playback from side “B”.