Filter
Top Products
2 - Modes
TASCAM CD-D4000
9
2.4 Compare CD-ROM
This mode is used for comparing a CD-ROM which
has just been duplicated using the copy mode. It can-
not be used for audio CDs.
1
Press the
MODE
key until the display shows the
following:
2
Press
ENTER
:
3
Make sure that the original disc is in the
MASTER
drive disc tray, and the copy disc is in
the
SLAVE
drive disc tray.
4
Press
ENTER
:
As the comparison process proceeds, the per-
centage of the process which has been com-
pleted is shown on the display.
Note that the comparison process is carried out
quicker than recording or testing. The time
taken for comparison is independent of any
speed settings made (these only affect the
recording speed).
5
When the comparison has finished successfully,
the display shows:
If there has been an error in the copying (i.e. the
two CD-ROMs do not match) or if they do not
match in any other way (the wrong pair of discs
has been loaded), the compare operation will
stop at the point at which the mismatch was
detected, and the display will show:
2.4.1 Error conditions
If no disc has been placed in either the
MASTER
or
SLAVE
drive, the display will show a
No disc
error
message, with the drive from which the disc is
missing.
If the master or slave disc is damaged, scratched, or
is otherwise unreadable, the display shows
Disc Err
,
with either
Master
or
Slave
as appropriate.
If the discs are different, the display shows a
No
match
message.
The compare operation can be stopped at any time by
pressing and holding down the
MODE
key and
pressing the
ENTER
key. An error message will be
displayed and you should use the
MODE
key to
return to the mode selection.
2.5 Play audio track
Since it is impossible to make a bit-by-bit compari-
son of audio CDs, this function is provided for you to
“audition” a CD copy, using a pair of headphones
connected to the
MASTER
or
SLAVE
drive head-
phone jack.
Any standard headphones with a 3.5 mm stereo jack
may be used. The volume is adjusted using the
drive’s volume control (turn to the right to increase
the volume, and to the left to decrease the volume.
1
Press the
MODE
key until the display shows the
following:
2
Press
ENTER:
3
Use the
MODE
key to toggle between
Master
and
Slave
, with a third option being to exit (
Exit
)
the play audio mode. Press the
ENTER
key to
confirm the selection:
After the
ENTER
key has been pressed, a
Please wait ...
message is briefly shown and
track 1 will start playing.
Pressing
ENTER
again will jump to the next
track and start playback. If the last track is
reached in this mode, and the
ENTER
key is
pressed, playback will start at the first track.
Mode select
3 Compare CD-ROM
Compare CD-ROM
Ready ?
Comparing ø
4%
Compare finished
Match
Compare finished
No match
Mode select
4 Play audio
Drive select
Master
Track 01 Play
1 Next track