Filter
Top Products
2 - Modes
10
TASCAM CD-D4000
4
If the
MODE
key is pressed from the screen
above, the display changes:
Pressing the
ENTER
key will start playing the
track before the current track. If the first track is
currently being played, and the
ENTER
key is
pressed, the last track will start playing.
5
Pressing the
MODE
key from the display shown
above will change the display again:
6
Press the
ENTER
key from this screen to exit the
audio play mode and return to the main mode
selection screen.
An appropriate error message is displayed if there is
no disc in the drive (
No disc
), or if the disc is
unreadable for any reason (it is not a finalized disc, or
is wrongly inserted into the drive, does not contain
audio data, etc. (
Bad disc
)),
NOTE
If the copied CD contains audio errors, you
will be able to hear them, but no message will
appear on the display. If a copied CD contains
audible errors, you may want to consider re-
recording at a lower speed, which will almost
certainly reduce the error rate.
2.6 Setting the writing speed
The CD-D4000
SLAVE
drive is capable of writing
information to a CD or CD-ROM drive at normal
(
1X
), double (
2X
) or four times (
4X
) normal speed.
The writing speed is set as described below.
Once the speed is selected, it is used in the CD copy-
ing and testing modes. It has no effect on the com-
pare operations.
1
Press the
MODE
button until the display shows:
2
Press
ENTER
.
3
Press the
MODE
key to cycle between quadru-
ple-speed (
4X
), double-speed (
2X
) and real-time
(
1X
) mode.
4
Press
ENTER
to confirm the selection.
NOTE
If you are in doubt what speed will work best,
pick real-time first and experiment with the
faster settings later. Usually, however, you
should be able to copy most discs at the
4x
speed.
Track 05 Play
2 Previous track
Track 05 Play
3 Exit
Mode select
5 Write speed
Speed select
4X Write