Filter
Top Products
TASCAM CD-160MKll 9
1 − Introduction
If batteries are used improperly, or if leakage or breakage
occurs, the unit will not function.
Please observe the cautions indicated on the batteries and
their packaging to ensure proper usage.
Confirm + and – polarity and follow the indications
when inserting new batteries into the remote control.
Do not use old and new batteries together.
Even if the battery is the same size, the voltage may differ.
Do not use batteries of different specifications together.
Do not attempt to recharge batteries that are non-
rechargeable.
Do not open or disassemble batteries, throw them into a
fire or put them in water.
•
•
•
•
•
Batteries
Inserting batteries
1. Open the lid.
2. Confirm +/- polarity, and insert two AAA batteries.
3. Close the lid.
ª
Connections
CAUTION
Turn off the power of all the equipment before
making connections.
Read instructions of each component you intend to
use with this unit.
Be sure to insert each plug securely. To prevent hum
and noise, do not bundle the connection cords with
the power cord.
Connect
ANALOG OUTs (L,R)
jacks to the input jack of
the amplifier with a RCA cable. Make sure to connect:
white plug
∑
white jack (L: left channel)
red plug
∑
red jack (R: right channel)
Use an optical cable to output the signal from the
DIGITAL
OPTICAL OUT
to the amplifier or recorder's input.
Use a RCA cable to output the signal from the
DIGITAL
COAXIAL OUT
to the amplifier or recorder's input.
After all other connections are complete, connect the plug
to the AC wall socket.
R
L
CD-160MK#
ANALOG IN
DIGITAL IN
DIGITAL IN
NOTE
Before making a recording with a recorder con-
nected to this unit's digital outputs, you need to
standby this unit in playback mode.
Be sure to connect the power cord to an AC outlet
which supplies the correct voltage. Hold the power
plug when plugging or unplugging the power cord.
Never pull or yank on the power cord.
The Digital output on the CD-160MkII does not in
-
clude track increment data. Some recorders depend
on this information to automatically update track
numbers while dubbing. If you need this function,
please connect the CD-160MkII and the recording
device with the analog connections and use "level
detection" mode on the recorder to detect track
changes (please refer to the manual of the recorder
for how to select this mode).