Filter
Top Products
6 TASCAM CD-160MKll
Thank you for your purchase of the TASCAM
CD-160MKII Compact Disc Player.
Before connecting and using the unit, please take time
to read this manual thoroughly to ensure you understand
how to properly set up and connect the unit, as well as the
operation of its many useful and convenient functions.
After you have finished reading this manual, please keep it
in a safe place for future reference.
Rack-mounting the unit
If you are mounting the unit in a rack, leave 1U of space
above it and 4 inch (10 cm) or more of space at the rear.
Use the rack-mounting kit to mount the unit in a standard
19-inch equipment rack, as shown in this section. Remove
the feet of the unit before mounting.
Supplied accessories
In addition to this manual, the CD-160MKII has been
packed with the following:
• RC-162C remote control unit ..........................................1
• A rack-mounting screw kit (screws and washers) ..........1
• AAA batteries for the remote control unit .....................2
• A waranty card ................................................................1
Contact your TASCAM supplier if any of these items are missing.
Precautions and notes for placement and use
The CD-160MKII may be used in most areas, but to main-
tain top performance, and prolong operating life, observe the
following notes, precautions and environmental conditions:
Avoid exposing it to extremes of temperature and
humidity and avoid mechanical shocks and vibration.
Keep the unit away from strong magnetic fields (TV
sets, computer monitors, large electric motors, etc.).
The nominal temperature should be between 5°C and
35°C (41°F and 95°F).
•
•
•
Relative humidity should be 30 to 90 percent.
As the unit may become hot during operation, always
leave sufficient space above the unit for ventilation. Do
not install this unit in a confined space such as a book-
case, and do not put anything on top of the unit.
Avoid installing this unit on top of any heat-generating
electrical device such as a power amplifier.
Make sure that the unit is mounted in a level position for
correct operation.
•
•
•
•
About this manual
In this manual, we use the following conventions:
The names of keys and controls are given in the follow-
ing typeface: PROGRAM.
When the alphanumeric portion of the display shows a
message, this is shown in the following typeface: NONE.
If a preset indicator in the display (i.e. one which cannot
change) is shown, this is shown as follows: EPS.
•
•
•
1 − Introduction