Filter
Top Products
17
TROUBLESHOOTING
Troubleshooting
PROBLEM CAUSE/REMEDY
No power when the unit is turned on. - Switch on the electric current at the socket.
- Check that the plug has been correctly inserted into the
socket.
- The internal fuse has blown and must be replaced by a
qualified service technician.
- The power cord has been damaged and must be
replaced.
No sound. - The unit has not been turned on.
- Incorrect connection to the amplifier.
- No loudspeakers have been connected to the amplifier.
- The DAB-50 has not found any stations on DAB.
The display does not show DAB/RDS - The DAB-50 has not found any stations on DAB/FM.
information. - The selected station does not broadcast any information.
- The antenna signal is too poor. See the section on
adjusting the antenna.
I cannot hear the station selected - You have not pressed the CONTROL/TUNING button
after selection. The station that you listen to will be
described in the top line of the display. When you "scroll"
through the channels by means of the CONTROL/TUNING
button, you must always remember to press the
CONTROL/TUNING button once to confirm your choice.
I can hear “tick/blob” sounds at - Like all other digital media DAB is reproduced in a
some of the stations. very high sound quality. But if the antenna signal is too
weak, you will not hear any whistling but instead you will
hear blackouts or "tick/blob" sounds. You must therefore
check if the antenna signal is strong enough. See the
section on adjusting the antenna.