SV Sound SVS PB13 Speaker User Manual


 
Setup, calibrating and integration
What’s to know?
Well, first of all, setting up an SVS subwoofer is
pretty darn easy. There are a few key things to give attention to if you
want to get the most out of your sub.
Unpacking.
You’re probably eager to hear your sub, but take time to
carefully unpack everything. Save the box and shipping materials, just
in case you need to return the sub for any reason.
Location.
They say it’s ALL about location right? It’s the same with
subwoofers. So, where to put it?
Go for a corner
if you can, and avoid
putting your sub where it might adjoin large open areas
.
Studies have
shown that the deepest and flattest bass response is typically attained
when a subwoofer is placed within a few feet of one of your room’s
corners (leave about 3” in the back for cable clearance with any wall or
other surface). A corner near your favorite seat is often the best location
of all. Whether you put the sub in front or to the rear of your seating
area makes surprisingly little difference. Deep home theater bass, like
that from “7.1 channel” movie or music is non-directional. You can’t
tell where it is coming from, even though you can hear, and feel it.
Hook-up
(see Fig. 1). There are a variety of ways to configure your
new sub. Usually, a simple mono, shielded 75 Ohm A/V RCA type
cable (a.) is used to take the subwoofer output of your DD/DTS
surround sound receiver
(b.)
and feed one low-level input of the sub’s
amp. There is no need to “split” the signal going to the sub (c.).
You
can feed either one of the two amp inputs, it doesn’t matter, right or
left.
DD/DTS Processor/Receiver
(Subwoofer “Out”)
Fig. 1
(a.)
(b.)
(c.)
SV Subwoofers
Page 6
SV Sound
NOTE: Stop now if you aren’t
TOTALLY familiar with your re-
ceiver’s manual. Ensure all power
to your equipment is off when
making these connections. Also, be certain
your power outlet can handle a minimum of
1000 watts. (Use of “convenience outlets” on
receivers are not recommended for your sub).