Filter
Top Products
13
User's Manual
User's Manual
User's Manual
User's Manual
11. Unplug the microphone and store it in a
safe place.
12. Finish the setup by adjusting the Atmos
VOLUME, CROSSOVER and PHASE
appropriately and calibrating your
surround sound receiver/processor
according to its owner’s manual.
13. If you add/remove heavy draperies or
large furniture or move the Atmos to a
new acoustic environment repeat steps
6-12.
Resetting the EQ
1. Turn off the subwoofer using the AC
power switch.
2. Hold down the Start button and turn on
the AC power switch.
3. Keep the Start button held down for 10
seconds while the blue EQ LED ashes.
4. When the LED goes out, the EQ is reset
to the at factory setting.
Using Two Subwoofers
1. If you are using two ATMOS subwoofers,
make sure that they are connected us-
ing the SLAVE output of the rst sub to
the SLAVE input of the second.
2. Connect the microphone to the rst
ATMOS subwoofer only.
3. Follow the procedure on the previous
page. The EQ room measurement will
take into account the sound from both
subwoofers, and the EQ adjustment will
affect both subwoofers.