Filter
Top Products
10
User's Manual
User's Manual
User's Manual
User's Manual
Please consider the following when set-
ting up your new system :
• Before making or changing any
connec tions, ALWAYS make sure
that the subwoofer and your other
components are turned OFF. Also
turn down the volume control of the
subwoofer and your preamplier or
receiver.
• This diagram shows all the low
power components sharing a power
strip which is connected to the same
outlet used by the amplier.
• The subwoofer is connected to an
outlet on the same circuit breaker,
provided that the total system
current draw does not exceed the
breaker current rating.
• This arrangement will reduce the
possibility of an audible hum in your
system caused by a ground loop.
• Whenever possible, keep the
power cords away from the signal
cables or speaker wires to prevent
any hum or interference being
heard in the speakers.
• Choose reliable, high quality inter-
connect cables, also called patch
cords or RCA cables. They should
be fully shielded and as short as
possible for the job. The longest
cable in your system will likely be to
the subwoofer, so choose a good
quality brand.
• Some patch cords can be a very
tight t and there is usually a
preferred method of getting them
off. Some have to be removed with
a twisting action. Be gentle or you
may damage the jacks of the sub-
woofer or your other components.
Connections