Filter
Top Products
User's Manual
17
APPENDIX
• Check that the interconnect cables
to the amplifi er do not have any
broken con nec tions.
Other causes of noise
• Speaker noise may also be caused
by in ter fer ence or noise on your
AC line. Make sure there are no
large ap pli anc es sharing the line,
or halogen lamps or lamps with
dimmer controls.
• Try connecting your system to an-
other AC socket on a sep a rate line.
• Keep power cords away from au-
dio cables.
• Do not place the preamplifi er di-
rectly on top of the amplifi er.
• If the hum is heard from within
the amplifi er and not through the
speak ers, this may also be caused
by in ter fer ence on the AC or DC
lines. The power trans form er
may turn this interference into an
audible noise. Internal hum can be
made worse by a shelf or cabinet
resonating, so try moving the am-
plifi er to another shelf.
• Try moving your preamplifi er
further away from your amplifi er.
Sensitive preamp circuits may pick
up hum from the am pli fi er trans-
former’s magnetic fi eld.
• Try moving your components further
away from the TV, es pe cial ly if
you ever notice the screen has
changed color in the area closest
to the component.
• If you have very high effi ciency
speak ers, these may show up
noise which other speakers may
not.
• If you are still having a problem,
re mem ber that Sun fi re’s dealers
and technical support staff will as-
sist you. Make a list of the things
you have tried.
Poor bass performance
• Make sure that your preamp does
not have the bass level turned
down.
• Many surround preamplifi ers have
con trols which can direct all the
bass to sub woof ers, or let your
main speakers play the full range.
Make sure that the preamplifi er
has been correctly set. If you are
not using a subwoofer, set the
speaker options to “LARGE,” and
the subwoofer to "OFF."
• Check that the speaker wires have
been connected correctly: Make
sure that the positive of each
speaker connects to a positive out-
put of the amplifi er, and the neg-
a tive of each speaker connects to
a neg a tive output. If one speaker is
wired incorrectly, than it will be “out
of phase” with the others, resulting
in poor bass performance.
• If you have connected the amplifi er
using the XLR inputs, make sure
that the XLR cables are wired cor-
rectly. If one has the hot and cold
reversed, then this will also cause
a speaker to be out of phase.
Turn-on and turn-off
thumps
• Plug the amplifi er into an
unswitched AC outlet, and use the
AUTO-ON feature. This will allow
the amplifi er to turn on and off
silently.
Current source outputs not
work ing
• If you are biamping or biwiring,
make sure that the current source
fuses have not blown.