Filter
Top Products
User's Manual
Bafe installation procedure
1. Remove the debris shield from the
front of the in-wall cabinet. You can
do this by cutting the cardboard
with a sharp knife and pulling out
the cardboard pieces and the plas-
tic rivets holding it in place. Do not
cut the two wires inside the cabinet,
and do not remove any sound-
proong material.
2. With the help of an assistant, hold
the bafe assembly close to the
in-wall cabinet.
3. Connect the two wires from the
inside of the cabinet to the two
push-terminals on the crossover
board, following this diagram:
4. Secure the woofer bafe assem
-
bly to the in-wall cabinet using 14
Allen-head screws and washers
supplied. Make sure the two wires
do not get pinched.
5. Before putting the grille frame and
grille on, test the subwoofer to see
if all the connections are made
correctly. See the user's guide that
comes with your SubRosa ampli-
er.
Bafe Install
17
Red Wire
(Positive +)
Black Wire
(Negative –)
Attaching the cabinet wires to the crossover
board xed to the woofer bafe assembly
(I-BEAM omitted for clarity)
Removing the debris shield
Installing the woofer bafe assembly
The woofer bafe assembly in place