Filter
Top Products
4
CONTROLS OVERVIEW
16. ANTI SKATE KNOB - When a record is playing, a force is
generated drawing the stylus towards the center of the record. This
control compensates for that force and needs to be set to the same
value as the counter weight pressure ring.
17. TONE ARM BASE - The tone arm base includes tone arm rest.
18. COUNTERWEIGHT - Use this to balance the tone arm and to adjust
the stylus pressure. See “Tone Arm and Cartridge Settings” for proper
adjustments.
19. 45-RPM adapter HOLDER - Place the attached 45-rpm
adapter here. Push down the rear side of 45 rpm adapter to take it off.
20. EXTRA HEADSHELL HOLDER - Place extra headshell here.
21. PHONO/LINE OUTPUT L & R -This is the standard analog output
(RCA jacks) which can be connected either to a phono or line input on
any DJ mixer or stereo system, depending on the setting of the
phono / line selector.
22. PHONO/LINE SWITCH - Switches the output to either phono or line level.
23. USB SOCKET- Connect the USB cable (included) to this socket
and to a USB connector on your computer. After connecting the
turntable to your computer, you can record your vinyl to your hard
disk using the included Cakewalk Pyro 5 software.
Note: maximum USB cable length is 3m
24. DIGITAL OUTPUT - Use this output to connect your T.90USB to the
S/PDIF digital input of any equipped digital device, such as a CDR or
computer soundcard
25. POWER CORD CONNECTOR - Used to connect the included power
cord.
26. POWER SWITCH - This switch turns the power on or off, including
the motor and audio signal