Filter
Top Products
4
Rear Panel/Connections
STEREO INPUTS
For connection of the source signal, which will be routed to the eight outputs.
Use 1/4” TRS (stereo) plugs for balanced connections and 1/4“ TS (mono)
plugs for unbalanced signals. Maximum input level is +19 dBu.
SEND CHANNELS 1 TO 8
These connectors provide the balanced SEND signals from stereo channels
1 to 4 for connection to processor inputs. A send channel will only carry the
input signal if the corresponding switch is activated. Standard adapter cables
are readily available for these connections (Sub-D > XLR male or female or
Sub-D > 1/4“).
The Sub-D connectors are wired according to the Tascam standard:
The numbers on the cables correspond to the Router send channels as
follows:
Cable No. Send Channel Switch Position
1 Send 1 Left
2 Send 1 Right
3 Send 2 Left
4 Send 2 Right
5 Send 3 Left
6 Send 3 Right
7 Send 4 Left
8 Send 4 Right
Example: if switch 1 is activated, the left side of the stereo signal is present at
cable no. 1 and the right side at cable no. 2. Switch 2 routes the stereo signal
to cables 3 and 4 and so on.
1
14
13
25
GCHGCHGCHGCHGCHGCHGCHGCH
1234567 8
G= GROUND, C=COLD (-), H=HOT (+)
}
1
}
2
}
3
}
4