Filter
Top Products
Advanced Recording Operations
8
GB
Advanced Playback Operations
Locating a Track (Multi-AMS/
Auto Play/Memory Play)
You can locate the following/previous tracks within a
range of 30 tracks (Multi-AMS: Automatic Music
Sensor) or the beginning of a tape quickly (Auto Play).
You can even locate a specific point anywhere on a
tape (Memory Play).
h/H)0
RESET MEMORY
OFF
MPX
FILTER
DOLBY NR
BALANCE
AUTO CAL
REC LEVEL
0
1
2
3
4
5
6
7
8
9
10
CC
B
B
PHONES
L R
AUTO
REC MUTING RECPAUSE
RESET MEMORY
POWER
DIRECTION MODE
EJECT
SYNCHRO
FADER ARL
AMS
Note
Check the direction indicator of the deck. When you locate a
track on the reverse side (when ª lights up), press the
button(s) in the parentheses.
To locate Press
Notes
• The Multi-AMS function may not work correctly if:
— the blank space between tracks is less than 4 seconds
long.
— there is a passage of low frequencies or very low
volume within a track.
— the signal strength of the left and right channels are
very different.
• Even if the DIRECTION MODE selector is set to Å or
a, the deck stops when the current side reaches the end
during Multi-AMS operation. (TC-RE340 only)
• The tape counters are reset to “00 00” when you turn off
the tape deck.
The beginning of the
next or succeeding
tracks
(Multi-AMS)
) (or 0) as many times as you
want during playback.
For example, to locate 2 tracks
ahead, press twice.
The beginning of the
current track
(Multi-AMS)
0 (or )) once during playback.
The beginning of the
preceding tracks
(Multi-AMS)
0 (or )) as many times as you
want during playback.
For example, to locate 2 tracks
behind, press three times.
The beginning of a tape
(Auto Play)
MEMORY repeatedly until “M”
disappears in the display. Then
press 0 (or )) while holding
down · (or ª).
A particular point on a
tape (Memory Play)
MEMORY repeatedly until “M”
appears in the display. Find the
point you want, then press RESET to
reset the tape counter and to
memorize the point.
To locate the memorized point and
start playback, press 0 (or ))
while holding down · (or ª).
(Press 0 or ) to stop at “00 00”.)