Filter
Top Products
Getting Started
5
EN
Ç
L
R
PHONO
IN
Ç
ç
OUTPUT
LINE
L
R
INPUT
LINE
TAPE1/DAT
L
R
REC OUT IN
Tape deck, DAT deck, or MD deck
Use the configuration above to connect the OUTPUT and
INPUT jacks of:
—a tape deck or DAT deck to the TAPE1/DAT jacks.
—a tape deck or MD deck to the TAPE2/MD jacks.
Turntable
1 Remove the shorting plugs from the PHONO jacks before
connecting the cables (but not unless you connect a
turntable).
Do not attach the shorting plugs to any set of the REC
OUT jacks. Doing so may stop output from the amplifier
or cause the unit to malfunction.
2 Connect the audio connecting cords.
Tape deck
Amplifier
Amplifier Turntable
Note
To prevent hum, connect the earth lead to SIGNAL GND (y)
on the amplifier.
TV or video deck (TA-FE910R/FE710R/FE610R/FE510R/
FE310R only)
Ç
L
R
L
R
OUTPUT
LINE
AUX
IN
Amplifier TV or video deck
EON CONTROL (TA-FE910R/FE710R/FE610R/FE510R only)
Amplifier
Tuner
Ç
EON CONTROL
IN
EON CONTROL
OUT
If your tuner is equipped with an EON CONTROL OUT
terminal, connect it to the EON CONTROL IN terminal on
the amplifier to allow use of the EON (Enhanced Other
Networks) function of the RDS (Radio Data System) (see
page 8).
(+)
(–)
(+)
(–)
Speaker System Hookups
Overview
Here you learn how to connect speakers to the
amplifier. You can connect two pairs of speakers,
SPEAKERS A and B (TA-FE910R/FE710R/FE610R
only).
• TA-FE910R/FE710R/FE610R
• TA-FE210
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
Twist the stripped ends of the cord about 15mm. Be sure to
match the speaker cord to the appropriate terminal on the
components: + to + and – to –. If the cords are reversed, the
sound will be distorted and will lack bass.
• TA-FE510R/FE310R
SPEAKERS A SPEAKERS B
SPEAKERS
TAPE1 / DAT
TAPE2 / MD
R
RL
REC OUT
REC OUT
IN
IN
B
A
L
++––
RL
++––
INPUT
RL
AUX
TUNER
CD
PHONO
y
SPEAKERS
PHONO
IN
TUNER
IN
CD
L
R
IN
AUX
IN
TAPE2 / MD
REC OUT
IN
TAPE1 / DAT
REC OUT
IN
y
SPEAKERS
IMPEDANCE USE 4 - 16 Ω
+
–
+
–
RL
SPEAKERS
SPEAKERS
R
+–
L
–+
PHONO
IN
TUNER
IN
CD
L
R
IN
TAPE2 / MD
REC OUT
IN
TAPE1 / DAT
REC OUT
IN
y