Filter
Top Products
5
GB
FM aerial hookups
With an FM outdoor aerial, you can obtain a higher FM
broadcast sound quality. We recommend that you use
the supplied FM wire aerial only temporarily until you
install an FM outdoor aerial. For the specific location of
the FM ANTENNA terminal, see the illustration below.
What will I need?
• FM wire aerial (supplied) (1)
• FM outdoor aerial (not supplied) (1) and 75-ohm coaxial
cable with IEC female type connector (not supplied) (1)
Connect the supplied FM wire aerial or an FM outdoor
aerial (not supplied) to one of the FM terminals on the
back of this unit.
z
You can use two FM aerials (ST-SE700 only)
This tuner has two FM ANTENNA terminals, A and B,
for use with different types of FM aerials. For example,
you can connect an outdoor aerial to the A jack and
connect a cable aerial to the B jack. You can also switch
the aerial while using the signal meter to determine
which aerial gives the best reception for a particular
station.
Getting Started
Connecting a ground wire
If you connect an outdoor aerial, be sure to connect a
earth lead (not supplied) to the AM ANTENNA U
terminal (in addition to the AM loop aerial) for
lightning protection.
Amplifier hookups
Connect the tuner to an amplifier. Be sure to turn off
the power to both components before connection. For
the specific location of the terminals, see the illustration
below.
What cables will I need?
• Audio cord (supplied) (1)
Connect the white plugs to the white (L) jacks and the red
plugs to the red (R) jacks. Insert the plugs completely into
the jacks; incomplete connections may cause noise.
FM ANTENNA
IEC female type connector
FM wire aerial
ANTENNA
AFMB
75 COAXIAL
ANTENNA
AFMB
75 COAXIAL
FM outdoor aerial
IEC female type
connector
LINE OUT EON CONTROL
Red (R)
White (L)
White (L)
Red (R)
TUNER IN
RL
RL
LINE OUT
Amplifier
Tuner
z
If you have a Sony amplifier equipped with an EON
CONTROL IN terminal (ST-SE700 and ST-SE500 only)
Use the supplied EON connecting cord to connect the
EON CONTROL OUT terminal on the tuner to the EON
CONTROL IN terminal on your amplifier. This lets you
use the EON function (see page 13) when listening to
other components.
Amplifier
Tuner
EON CONTROL
OUT
EON CONTROL
IN
(continued)