Filter
Top Products
11
GB
Presetting Radio Stations
This section shows you how to store up to 30 of your
favorite FM or AM (MW and LW) stations manually
onto preset codes made up of characters (A, B, or C)
and numbers (1-0), such as A7. You can store up to 10
stations on each of the 3 different letters. You can use
these letters to classify stations according to music
category or station band.
1 Tune in the FM, MW, or LW station you wish to
store.
2 Press MEMORY.
“MEMORY” appears along with the lowest
vacant code to indicate that the tuner is ready to
store the station.
3 Press SHIFT to chose either A, B, or C.
The letter you choose appears in the display.
4 Press a numeric button (1-0).
The tuner stores the station at the preset code you
specified.
5 Repeat steps 1 through 4 to store other stations.
z
RDS Station names are stored automatically
When you preset an RDS station broadcasting station
name information, the station name is automatically
stored at the station preset.
z
If you want to label the stations
Follow the procedure described in “Naming Preset
Stations” on page 11.
Advanced Tuner Operations
Numeric
buttons
MEMORY SHIFT
Naming the Preset Stations
You can assign a name up to 13 characters long (5
characters for the ST-SE300) to each preset station
except FM RDS stations. When the station is tuned in,
the station name will appear instead of the frequency.
1 Press CHAR.
The cursor blinks in the display.
2 Turn TUNING/SELECT to select a character.
3 When the character you want appears, press
CHAR to move the cursor into position for the
next character.
If you make a mistake
Press CHAR repeatedly until the character you want to
change flashes (every time you press CHAR, the next
character flashes). Then turn TUNING/SELECT to
select a new character.
4 Repeat steps 2 and 3 until the station name you
desire appears in the display.
5 Press MEMORY.
“MEMORY” appears along with the lowest
vacant code to indicate that the tuner is ready to
store the station.
6 Press SHIFT and one of the preset buttons to
specify the preset where you want to store the
station name.
Note
The display returns to normal display mode if you stop
assigning names for more than 8 seconds. If this happens,
start again from the beginning.
z
To see the frequency of the displayed station name
Press DISPLAY repeatedly.
Numeric
buttons
MEMORY SHIFT
DISPLAY
CHAR
TUNING/SELECT