Filter
Top Products
23
GB
D:\NORM'S JOB\SONY HA\SO0173\STR-DH130\4294472111_GB\GB05BAS_STR-DH130-
U2.fm
masterpage: Right
STR-DH130
4-294-472-11(1)
Tuner Operations
1 Press TUNER repeatedly to
select the FM or AM band.
2 Press TUNING + or TUNING –.
TUNING + scans from lower to higher
frequency stations and TUNING – for
scanning higher to lower.
The receiver stops scanning whenever a
station is received.
Using the control buttons on
the receiver
1 Turn INPUT SELECTOR to select the FM
or AM band.
2 Press TUNING MODE repeatedly to select
“AUTO”.
3 Press TUNING + or TUNING –.
In case of poor FM stereo
reception
If the FM stereo reception is poor and “ST”
flashes on the display panel, select monaural
audio to lessen the sound distortion.
Press FM MODE repeatedly until the
“MONO” indicator lights up on the display
panel.
To return to the stereo mode, press FM MODE
repeatedly until the “MONO” indicator on the
display panel does not light up.
You can enter the frequency of a station
directly by using the numeric buttons.
1 Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2 Press D.TUNING.
3 Press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
• USA and Canada models only:
Select 1 b 0 b 2 b 5
• Other models:
Select 1 b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
Tip
Adjust the direction of the AM loop antenna
(aerial) for optimum reception upon tuning to
an AM station.
4 Press .
If you cannot tune to a station
“- - - .- - MHz” or “- - - - kHz” appears and then
the screen returns to the current frequency.
Make sure you have entered the right
frequency. Try repeating steps 2 to 4. If you
still cannot tune to a station, the frequency
may not be in use in your area.
Tuning to a station
automatically (Automatic
Tuning)
Tuning to a station directly
(Direct Tuning)