Filter
Top Products
28
GB
Recording using the
receiver
You can record onto a MiniDisc, audio tape,
video tape, etc. using the receiver. You can also
add audio from a variety of audio sources
when editing a video tape.
See the operating instructions supplied with
your recording component.
1 Press one of the input buttons
to select the playback
component.
You can also use INPUT SELECTOR on
the receiver.
2 Prepare the playback
component for playing.
For example, insert a CD into the CD
player.
3 Prepare the recording
component.
Insert a blank MD or tape into the
recording component.
4 Start recording on the
recording component, then
start playback on the playback
component.
Notes
•Sound adjustments do not affect the signal output
from the MD/TAPE OUT jacks.
•Some sources contain copy guards to prevent
recording. In this case, you may not be able to
record from the source.
Tip
You can record the sound from any audio source
onto a video tape while copying from a video tape.
Locate the point where you want to start recording
from another audio source, select the program
source, then start playback. The audio from that
source will be recorded onto the audio track of the
video tape instead of the audio from the original
medium. To resume audio recording from the
original medium, select the video source again.
Changing button
assignments
You can change the factory settings of the
input buttons to suit the components in your
system. For example, if you connect a DVD
recorder to the VIDEO jacks on the receiver,
you can set the VIDEO button on this remote
to control the DVD recorder.
Note
You cannot change the settings of TUNER and
DMPORT buttons.
1 Hold down the input button of
which you want to change the
assignment.
Example: Hold down VIDEO.
2 Referring to the table below,
press the corresponding
button for the category you
want.
Example: Press 3.
Now you can use the VIDEO button to
control the DVD recorder.
Using the Remote