Filter
Top Products
17
GB
Getting Started
Insert two R6 (size-AA) batteries in the
RM-AAU055 Remote Commander.
Observe the correct polarity when installing
batteries.
Notes
•Do not leave the remote in an extremely hot or
humid place.
•Do not use a new battery with old ones.
•Do not mix manganese batteries and other kinds of
batteries.
•Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
•If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the remote buttons
may be reset to their factory settings. If this
happens, reassign the buttons again (page 28).
•When the remote no longer operates the receiver,
replace all the batteries with new ones.
6: Selecting the speaker
system
You can select the speakers you want to drive,
if you have connected the speakers to
SPEAKERS
A and B terminals.
Be sure to use the buttons on the receiver for
this operation.
Press SPEAKERS (OFF/A/B/A+B)
repeatedly to select the speaker
system you want to drive.
To turn off the speaker output
Press SPEAKERS (OFF/A/B/A+B)
repeatedly until the “SP A” and “SP B”
indicators on the display do not light up.
Note
You cannot switch the speaker system by pressing
SPEAKERS (OFF/A/B/A+B) when the headphones
are connected.
Inserting batteries into the
remote
To select Light up
The speakers connected to the
SPEAKERS A terminals
SP A
The speakers connected to the
SPEAKERS B terminals
SP B
The speakers connected to both the
SPEAKERS A and B terminals
(parallel connection)
SP A
SP B
DISPLAY DIMMER MUTING
TUNING MODE
MEMORY/
ENTER
TUNING BASS TREBLE
SPEAKERS
(OFF/A/B/A+B)
INPUT SELECTOR
FM MODE
PHONES
MASTER VOLUME
SPEAKERS (OFF/A/B/A+B)