Filter
Top Products
7
GB
Getting Started
Use the function buttons (TV/LD, CD, MD/TAPE etc)
to select the VIDEO AUDIO OUT signal.
You can record this audio signal by connecting a
recording component such as a cassette deck (to the
VIDEO AUDIO OUT jack)
DVD player/AC-3 decoder
What cables will I need?
• Audio cable (not supplied) (1 for each 5.1 CH/DVD
FRONT and REAR jacks)
White (L) White (L)
Red (R) Red (R)
• Monaural audio cable (not supplied) (1 for each 5.1 CH/
DVD CENTER and WOOFER jacks)
Black Black
• Video cable (not supplied) (1 for the 5.1 CH/DVD VIDEO
IN jack)
Yellow Yellow
You can play decoded Dolby Digital AC-3
soundtracks through the speakers connected to the
amplifier.
If you have a Dolby Digital AC-3 decoder you can
amplify a decoded Dolby Digital AC-3 soundtrack with
the following connections.
Where do I go next?
Go on to the next section to connect the speakers.
(+)
(+)
(–)
(–)
Front speaker
(R)
Front speaker
(L)
Receiver
Receiver
Rear speaker
(R)
Rear speaker
(L)
Centre speaker
WOOFER
SPEAKERS
REAR
SPEAKERS
FRONT B
(continued)
Receiver
Dolby Digital AC-3
decoder, etc.
5.1 CH / DVD
FRONT FRONTREAR REARCENTER
L
R
CENTER
WOOFER
WOOFER
VIDEO IN
VIDEO
PRE OUT
Speaker System Hookups
Overview
This section describes how to connect your speakers to
the receiver. To enjoy surround effects, centre and rear
speakers and an active woofer are required. For
specific locations of the terminals, see the illustration
below.
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
Twist the stripped ends of the cord about 15 mm (2/3 inch).
Be sure to match the speaker cord to the appropriate
terminal on the components: + to + and – to –. If the cords
are reversed, the sound will be distorted and will lack bass.
Hookups
Front speakers
Rear and centre speakers
SPEAKERS
FRONT A
FRONT
AA
BB
L
R
L
R
SPEAKERS
REAR
LR
LR
CENTER
SPEAKERS CENTER