Filter
Top Products
7
US
Getting Started
(continued)
VCR
Use the function buttons (TV/SAT (TV/LD), CD, MD/
TAPE etc.) to select the VIDEO AUDIO OUT signal.
You can record this audio signal by connecting a
recording component such as a cassette deck (to the
VIDEO AUDIO OUT jack).
DVD player/AC-3 decoder
What cables will I need?
• Audio cable (not supplied) (1 for each 5.1 CH/DVD
FRONT and REAR jacks)
• Monaural audio cable (not supplied) (1 for each 5.1 CH/
DVD CENTER and WOOFER jacks)
• Video cable (not supplied) (1 for the 5.1 CH/DVD VIDEO
IN jack)
You can play decoded Dolby Digital AC-3
soundtracks through the speakers connected to the
amplifier.
If you have a Dolby Digital AC-3 decoder you can
amplify a decoded Dolby Digital AC-3 soundtrack with
the following connections.
Where do I go next?
Go on to the next section to connect the speakers.
Receiver VCR
AUDIO IN
VIDEO
VIDEO IN
AUDIO
OUTPUT
VIDEO
AUDIO
INPUT
VIDEO
AUDIO OUT
L
R
VIDEO OUT
L
R
Yellow
Yellow
White (L)
Red (R)
White (L)
Red (R)
Black
Black
Receiver
Dolby Digital AC-3
decoder, etc.
5.1 CH / DVD
FRONT FRONTREAR REARCENTER
L
R
CENTER
WOOFER
WOOFER
VIDEO IN
VIDEO
PRE OUT
Speaker System Hookups
Overview
This section describes how to connect your speakers to
the receiver. To enjoy surround effects, center and rear
speakers and an active woofer are required. For
specific locations of the terminals, see the illustration
below:
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
Twist the stripped ends of the cord about 2/3 inch (15 mm).
Be sure to match the speaker cord to the appropriate
terminal on the components: + to + and – to –. If the cords
are reversed, the sound will be distorted and will lack bass.
Hookups
Front speakers
WOOFER
SPEAKERS
REAR
SPEAKERS
FRONT B
SPEAKERS CENTER
SPEAKERS
FRONT A
(+)(+)
(–)
(–)
Front speaker
(R)
Front speaker
(L)
Receiver
FRONT
AA
BB
L
R
L
R
IMPEDANCE
SELECTOR