Filter
Top Products
Advanced Recording Operations
17
If your CD player does not have the Peak Search
function
The CD player changes to play pause and deck B to
recording pause. Press PAUSE P on deck B to start
Synchro-Recording.
To stop CD Synchro-recording
Press p on deck B or the CD player.
z You can use an optional remote (supplied for TC-
WE835S U.S.A. model only) to operate the CD player
To start CD play, press P twice; to pause CD play, press
P once; to locate a CD track, press = or +.
z If the SYNCHRO button indicator goes off after
flashing rapidly
The tape cannot be recorded on because the record-
protect tab(s) on the cassette has (have) been removed.
z Length of tape used for recording
Tracks on a CD differ in length. Classical music CDs
and others often have tracks that exceed the recording
time of a single cassette side. In this case, record the
tape manually.
z When recording from the middle of the tape
A tape that is inserted and has not been played or
recorded on is assumed by the deck to be a new tape,
even if the present location is in the middle of the tape.
The deck will transport the tape for 10 seconds before
starting CD Synchro-recording to bypass the portion
corresponding with the leader. To begin CD Synchro-
recording without the ten-seconds delay, play or record
on the tape for about 10 seconds before starting the CD
Synchro-recording procedure.
z If the tape ends during CD Synchro-recording on the
front side of the tape (· lights up) and the
DIRECTION MODE selector is set to a or RELAY
Recording of the track ends immediately, the tape
direction is reversed, and recording starts again from
the beginning of the track. If the tape ends on the
reverse side of the tape (ª lights up), CD Synchro-
recording stops and the CD player stops playing.
Notes
• To prevent interruption of the recording process, do not
press any operation buttons on the CD player during CD
Synchro-recording.
• Certain operation buttons on the tape deck are disabled
during CD Synchro-recording.
Synchro-recording With a CD
Player Using a Remote Z
By pressing the START button on the optional remote
RM-J910 (supplied for TC-WE835S U.S.A. model only),
you can perform Synchro-recording on your tape deck
with a Sony CD player. This function is possible only
with Sony CD players with remote control capability.
START
STANDBY STOP
PRESET
= P+
1 Set the source selector on the amplifier to CD
player.
2 Insert a CD into the CD player and select the play
mode (CONTINUE, SHUFFLE, or PROGRAM) of
the CD player.
3 Insert a cassette into deck B and select the side(s)
to be recorded.
To record on Set DIRECTION MODE to
Only one side A
Both sides a or RELAY
4 Press STANDBY.
· lights up and the CD player changes to play
pause and deck B to recording pause. If ·
doesn’t light up, press · once.
To record on the reverse side
Press ª once.
5 Press START.
To stop Synchro-recording
Press STOP.
z If your CD player has the Peak Search function
After performing Steps 1 to 3 above, press PRESET to
turn on the Auto Rec Level function (see page 12). Then
continue from Step 4.
z You can use the remote to operate the CD player
To start CD play, press P twice; to pause CD play, press
P once; to locate a CD track, press = or +.
Note
Some CD player might not start playback when you press
START. In this case, press P on the CD player to start
playback.