Filter
Top Products
Advanced Recording Operations
14
To stop dubbing
During Press
Normal-speed dubbing p on deck B
High-speed dubbing p on either deck
z During high-speed dubbing
Only the p button is operative.
z You don‘t have to adjust the recording level or
select the Dolby NR during dubbing
Dubbing is automatically performed with the same
recording level and Dolby NR as the original in deck A.
If, however, you want to monitor the sound during
normal-speed dubbing, set the DOLBY NR selector to
match the tape in deck A (see page 5).
z You can adjust the pitch of the playback on deck A
See page 5.
Note
If a TV set is placed near the tape deck, noise may occur
during high-speed dubbing. In that case, turn the television
set off or move it away from the tape deck.
Dubbing only specific portions
You can do this only during the normal-speed
dubbing.
1 Press p on deck A at the portion you want to
skip.
Deck B changes to recording pause.
2 Locate the point you want to resume recording on
deck A, then stop the tape.
3 Press PAUSE P on deck B to resume dubbing.
Recording on Both Decks in
Succession (Relay Recording)
You can make a continuous recording that starts on a
cassette in deck A and ends on a cassette in deck B.
ª/·
DIRECTION MODE
REC r
0
p
P
ª·
)
U
§§
Rr PRr
0
p
ª·
)
•
1 Insert blank cassettes into both decks.
Make sure that record-protect tabs on the
cassettes have not been removed.
2 Select the Dolby NR (see page 7).
3 Set DIRECTION MODE to RELAY.
4 Press REC r on deck A.
Deck A changes to recording pause.
5 Start playing the program source.
6 Adjust the recording level manually, if necessary
(see page 7).
7 Start recording.
To record from Press
The front side · on deck A
The reverse side ª on deck A
To stop Relay Recording
During Press
Recording on deck A p on deck A
Recording on deck B p on deck B
Note
Make sure that · on deck B appears in the display. If it
doesn’t, press · on deck B once; otherwise, Relay
Recording stops when the reverse side of the cassette in deck
B finishes.