Filter
Top Products
9
Playing a Tape
4 Press SET to store your selection.
To program the same track again, press SET
once more.
1 3
H
1234567891011121314
FRONT
RMS
BACK
5 Repeat Steps 2 to 4 to program more
tracks.
If “FULL” appears in the display
This means that you’ve already programmed 28
tracks and can’t program any more.
6 Press RMS/START to start RMS Play.
The peak level meters appear in the display.
To stop RMS Play
Press x (CLEAR) once. The RMS program
still remains. To resume RMS play, press
RMS/START.
To cancel RMS Play
Press x (CLEAR) repeatedly until the peak
level meters appear in the display or eject the
tape in deck A. When RMS Play is canceled,
the RMS program is automatically erased.
To alternate between the RMS and
peak level meter displays
Press DISPLAY.
Tip
To play the program again after RMS Play ends, press
RMS/START.
Notes
• During RMS Play, you can only use CHECK,
DISPLAY, and x on deck A, and x, m, and M
on deck B.
• The RMS function may not work properly if a blank
space between tracks is short.
• If there is a long blank space between tracks, the
deck may fast-forward a portion of the blank space.
• If your program includes a number for a track that
does not exist, the deck will skip that number
during RMS Play.
Checking the order of tracks
in the program
Press CHECK.
Each time you press this button, the display
shows the track numbers in the order they were
programmed. After the last track in the
program, “End” appears in the display.
Adding tracks to the end of a
program
Press x (CLEAR) once, and follow Steps 2 to
5 in “Creating your own program (RMS Play)”
on page 8.
Note
For more information on the availability of Sony
stereo receiver remotes with RMS capability, contact
your nearest Sony dealer.
Order on the program
Track number