Filter
Top Products
6
Getting Started
CD player
to an AC outlet
Amplifier
Hooking up the system
This section describes how to hook up the tape deck to an amplifier or a CD player equipped with
CONTROL A1II connectors. Be sure to turn off the power of each component before making the
connections.
Hookups
Connecting the tape deck to an
amplifier
Connect the amplifier to the IN/OUT
connectors using the supplied audio connecting
cords.
When connecting an audio connecting cord, be
sure to match the color-coded cord to the
appropriate jacks on the components: Red
(right) to Red and White (left) to White. Be
sure to make connections firmly to avoid hum
and noise.
Connecting the tape deck to a CD
player equipped with CONTROL A1II
connectors
For details, see “Using the CONTROL A1II
control system” on page 17.
Setting the voltage selector
(only on models supplied with
a voltage selector)
Check that the voltage selector on the rear
panel of the tape deck is set to the local power
line voltage. If not, set the selector to the
correct position using a screwdriver before
connecting the AC power cord to an AC outlet.
220V
120V
VOLTAGE
230 –
240V
Connecting the AC power cord
Connect the AC power cord to an AC outlet.
Note
Install this system so that the power cord can be
unplugged from the wall socket immediately in the
event of trouble.