Filter
Top Products
7
US
Getting Started
DVD player/AC-3 decoder
What cables will I need?
• Audio cable (not supplied) (1 for each 5.1 CH/DVD
FRONT and REAR jacks)
• Monaural audio cable (not supplied) (1 for each 5.1
CH/DVD CENTER and WOOFER jacks)
• Video cable (not supplied) (1 for the 5.1 CH/DVD
VIDEO IN jack)
You can play decoded Dolby Digital AC-3 soundtracks
through the speakers connected to the amplifier.
If you have a Dolby Digital AC-3 decoder you can
amplify a decoded Dolby Digital AC-3 soundtrack with
the following connections.
Where do I go next?
Go on to the next section to connect the speakers.
Speaker System Hookups
Overview
This section describes how to connect your speakers to
the receiver. Although front (left and right) speakers
are required, center and rear speakers are optional.
Adding center and rear speakers will enhance the
surround effects. Connecting an active woofer will
increase bass response. For specific locations of the
terminals, see the illustration below.
For optimum surround sound effect, place your
speakers as shown below.
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
Twist the stripped ends of the cord about 2/3 inch (15 mm).
Be sure to match the speaker cord to the appropriate
terminal on the components: + to + and – to –. If the cords
are reversed, the sound will be distorted and will lack bass.
White (L)
Red (R)
White (L)
Red (R)
Black Black
Yellow Yellow
FRONTREARCENTER
WOOFER
VIDEO
PRE OUT
5.1 CH/DVD
FRONT REAR CENTER
WOOFER
VIDEO
L
R
Receiver
Dolby Digital AC-3
decoder, etc.
WOOFER
SPEAKERS
FRONT A
SPEAKERS
CENTER
SPEAKERS REAR
SPEAKERS
FRONT B
60 - 90 cm
Rear speaker
45°
(+)(+)
(–)
(–)
(continued)