Filter
Top Products
Additional Information
20
US
Specifications
Amplifier section
Power output
Stereo mode
Surround mode
and 5.1 CH/DVD
(Reference)
Frequency
response
Canada model:
(8 ohms 20 Hz - 20 kHz,
less than 0.09% total
harmonic distortion)
100 W + 100 W
Australia, Singapore and
Malaysia models:
Rated power: (8 ohms at
1 kHz, THD 0.7%)
80 W + 80 W
Reference power:
(8 ohms 20 Hz - 20 kHz,
less than 0.09% total
harmonic distortion)
70 W + 70 W
Other countries:
Rated power: (8 ohms at
1 kHz, THD 0.7%)
100 W + 100 W
Reference power: (8 ohms
20 Hz - 20 kHz, less
than 0.09% total
harmonic distortion)
95 W + 95 W
Canada model:
(8 ohms at 1 kHz, THD
0.8%)
Front: 80 W/ch
Center: (Pro Logic mode)
80 W
Rear: 80 W/ch
Other countries:
Rated power: (8 ohms at
1 kHz, THD 0.7%)
Front: 80 W/ch
Center: (Pro Logic mode)
80 W
Rear: 80 W/ch
Reference power: (8 ohms
20 Hz - 20 kHz, less
than 0.09% total
harmonic distortion)
Front: 70 W/ch
Center: (Pro Logic mode)
70 W
Rear: 70 W/ch
RMS power: (8 ohms at
1 kHz, THD 10%)
Front: 100 W/ch
Center: (Pro Logic mode)
100 W
Rear: 100 W/ch
TV/SAT (TV/LD), CD,
MD/TAPE, VIDEO,
5.1 CH/DVD:
10 Hz - 50 kHz ±1 dB
Video section
Antenna
Intermediate
frequency
Usable sensitivity
S/N
Harmonic
distortion
Selectivity
Inputs
Output
System
Power
requirements
Canada and other
countries:
530 - 1610 kHz (10 kHz
step)**
531 - 1602 kHz (9 kHz
step)
Loop aerial
450 kHz
50 dB/m (at 999 kHz)
54 dB (at 50 mV/m)
0.5 % (50 mV/m, 400 Hz)
At 9 kHz: 35 dB
At 10 kHz: 40 dB
VIDEO, TV/SAT (TV/
LD), 5.1 CH/DVD:
1 Vp-p 75 ohms
VIDEO, MONITOR:
1 Vp-p 75 ohms
Tuner section: PLL
quartz-locked digital
synthesizer system
Preamplifier section:
Low-noise NF type
equalizer
Power amplifier section:
Pure-complementary
SEPP
Canada model:
120 V AC, 60 Hz
Australia model:
240 V AC, 50 Hz
Singapore and Malaysia
models:
230 V AC, 50/60 Hz
General
CD,
5.1 CH/
DVD,
MD/TAPE,
TV/SAT
(TV/LD),
VIDEO
Sensitivity
250 mV
Impedance
50
kilohms
S/N
80 dB
Inputs
Outputs
Muting
BASS BOOST
TONE
Tuning range
Antenna terminals
Intermediate
frequency
Sensitivity
Usable sensitivity
S/N
Harmonic
distortion at
1 kHz
Separation
Frequency
response
Selectivity
Tuning range
+0.5
–2
Tuner section
FM stereo, FM/AM superheterodyne tuner
FM tuner section
AM tuner section
MD/TAPE REC OUT:
Voltage: 250 mV,
Impedance: 10 kilohms
VIDEO AUDIO OUT:
Voltage: 250 mV,
Impedance: 10 kilohms
WOOFER:
Voltage: 2 V
Impedance: 1 kilohms
PHONES: Accepts low
and high impedance
headphones
Full mute
+10 dB at 70 Hz
±8 dB at 100 Hz and
10 kHz
87.5 - 108.0 MHz
75 ohms, unbalanced
10.7 MHz
Mono: 18.3 dBf, 4.5 µV
Stereo: 38.3 dBf, 45 µV
11.2 dBf, 1 µV (IHF)
Mono: 76 dB
Stereo: 70 dB
Mono: 0.3 %
Stereo: 0.5 %
45 dB at 1 kHz
30 Hz - 15 kHz dB
60 dB at 400 kHz
Singapore, Malaysia and
Australia models:
531 - 1602 kHz (9 kHz
step)
**You can change the AM tuning interval
between 9 kHz and 10 kHz. Turn off the
receiver and press 1/u (power) for more
than 4 seconds until “INITIAL” appears.
1) After tuning in any AM station, turn
off the receiver.
2) Hold down PRESET TUNING +
button and press the 1/u (power)
button. “9k STEP” appears.
To change to 10k Step, repeat step 1 and 2
until “10k STEP” appears. Note that all
preset stations, index names and sound
field are cleared after you make the
procedure above.