Filter
Top Products
13
Additional Information
Specifications
Audio power specifications
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION
With 8-ohm load, both
channels driven, from 20 -
20,000 Hz, rated 100 watts
per channel minimum RMS
power, with no more than
0.1 % total harmonic
distortion from 250
milliwatts to rated output.
Amplifier section
Dynamic power
output
Frequency
response
USA model:
8 ohms: 150 W + 150 W
4 ohms: 210 W + 210 W
Canadian model:
8 ohms: 140 W + 140 W
4 ohms: 180 W + 180 W
PHONO: RIAA
equalization curve
±0.5 dB
CD, TAPE/MD, VIDEO:
10 Hz - 50 kHz ±1 dB
General
Tuner section: PLL
quartz-locked digital
synthesizer system
Preamplifier section:
Low-noise NF type
equalizer
Power amplifier section:
Pure-complimentary
SEPP
120 V AC, 60 Hz
USA model: 175 W
Canadian model: 270 AV
1 switched, total 120 W/
1A Max
17 x 5
3
/4 x 11
5
/8 inches
(430 x 145 x 295 mm)
7.0 kg (15 lb 6 oz)
FM wire antenna (1)
AM loop antenna (1)
Remote controller
(remote) (1)
Size AA (R6) batteries (2)
System
Power
requirements
Power
consumption
AC outlets
Dimensions
Mass (Approx.)
Supplied
accessories
Design and specifications are subject to
change without notice.
+0.5
–2
Outputs
Muting
BASS BOOST
TONE
TAPE/MD REC OUT:
Voltage 150 mV,
Impedance 10 kilohms
VIDEO AUDIO OUT:
Voltage 150 mV,
Impedance 10 kilohms
PHONES: Accepts low
and high impedance
headphones
Full mute
+10 dB at 70 Hz
±8 dB at 100 Hz and
10 kHz
FM tuner section
Tuning range
Antenna
terminals
Sensitivity
Usable sensitivity
S/N
Harmonic
distortion at
1 kHz
Separation
Frequency
response
Selectivity
Tuning range
Antenna
Usable sensitivity
S/N
Harmonic
distortion
Selectivity
87.5 - 108.0 MHz
75 ohms, unbalanced
300 ohms, unbalanced
Mono: 18.3 dBf, 4.5 µV
Stereo: 38.3 dBf, 45 µV
11.2 dBf, 2 µV (IHF)
Mono: 76 dB
Stereo: 70 dB
Mono: 0.3 %
Stereo: 0.5 %
45 dB at 1 kHz
30 Hz - 15 kHz dB
60 dB at 400 kHz
With 10 kHz interval**:
530 - 1710 kHz
With 9 kHz interval:
531 - 1710 kHz
Loop antenna
50 dB/m (at 1,000 kHz or
999 kHz)
54 dB (at 50 mV/m)
0.5 % (50 mV/m,
400 Hz)
At 9 kHz: 35 dB
At 10 kHz: 40 dB
** You can change the AM tuning interval
to 9 kHz. After tuning in any AM station,
turn off the receiver. Hold down the
TUNING + button and press the POWER
button. All preset stations will be erased
when you change the interval. To reset
the interval to 10 kHz, repeat the
procedure.
Inputs
PHONO
(MM)
CD
TAPE/
MD,
TV,
VIDEO
S/N
(weighting
network,
input level)
74 dB
72 dB*
(A, 2.5 mV)
82 dB
82 dB*
(A, 150 mV)
Impedance
50
kilohms
50
kilohms
Sensitivity
2.5 mV
200 mV
150 mV
* ‘78 IHF
AM tuner section